What kind of rifle is the Remington Model 510?
It is a Remington Model 510, Targetmaster. It is a single shot, bolt action, .22 rimfire rifle. I took it apart and cleaned it up and refinished the stock. It turned out pretty nice. Here it is.
Is the breach bolt on a Remington Model 510?
This is the complete breach bolt removed from a Remington model 510 Targetmaster 22 rifle. It is in good used condition Thanks for looking. 1.RcmdId ViewItemDescV4,RlogId p4%60bo7%60jtb9%3Fuk.rp73%28b0g%60%60%3E1-148afc75051-0x107- This is the stock screw removed from a Remington model 510 Targetmaster 22 rifle.
What kind of magazine does a Remington 514 use?
Remington Models 510 and 514 are single shots. Remington 511 Scoremaster has detachable magazine (1936-1963) 6-round or 10-round Remington 512 Sportsmaster has a tubular magazine (1940-1962)
Is the Remington 511 Scoremaster a single shot?
Remington Models 510 and 514 are single shots. I think I would prefer the Remington 511 Scoremaster. I have a Ruger 10/22 and Mag Tec 7022, but I don’t have a bolt action .22 rifle. It would be nice to have a Winchester Model 52, but I just cannot justify the price of those. Remington Models 510 and 514 are single shots.
When does safety come on on Remington 510?
The 510 is designed to have the safety become active after every shot. The others are repeaters and the safety does not come into play after each shot. Thanks for the additional information. I reviewed the limited information on the Remington website. That is where there is a refference to the 1954 date.
What kind of sight does a Targetmaster 511-p have?
The 511-P was made for a Point-Crometer rear sight and a patridge type from sight. The stock should be cut away slightly for the sight on its left side at the rear of the action. Depending on the year of production, it should have a grooved receiver.
Is there a scope rail on a Remington 511 P?
On a side note, yesterday I found a Remington 511-P. It looked like it was factory drilled for a receiver peep but some one had affixed a kind of side mount scope rail. My guess is that this was accomplished by using the drill and tap method. Please let me know if the 511-P was factory d & t for a scope rail.