Welche Aufgaben hat das einrückrelais?
Mittels Starten des Motors über das Zündschloss wird das Einrückrelais betätigt. Durch den Stromfluss in der Einzugs-, und Haltewicklung wird der Relaisanker angezogen. Dadurch wird der Einrückhebel betätigt und schiebt die Mitnehmereinheit mit Ritzel und Freilauf gegen den Zahnkranz des Motorschwungrads.
Was macht die Haltewicklung?
Bei eingeschaltetem Startschalter erhalten die Einzugwicklung (links) und die Haltewicklung (rechts) über die Klemme 50 Strom und bewegen durch magnetische Induktion einen Eisenkern in axialer Richtung. Dieser zieht über einen Hebel das kleine Ritzel des Anlassers in Richtung Schwungrad.
What does a starter solenoid do on a Harley Davidson?
The starter solenoid should make a clicking sound while providing a 12-volt reading on the voltmeter’s display, indicating that power is being routed from the starter button to the starter solenoid and relay.
What to do if your starter solenoid is defective?
The starter solenoid is defective if the pinion gear does not extend outward into its at-rest position. Slide the starter motor into position from the right side of the engine. Screw the starter motor mounting bolts into place and tighten them to 22 foot-pounds.
Where is the starter located on a Harley Davidson?
Unscrew the starter mounting bolts using a socket wrench. The bolts are from the right side of the engine on most Harley-Davidson models; however, Sportster models locate the bolts within the primary chaincase on the left side of engine. Pull the starter out from the right side of the engine.
Why does the solenoid go clunk when the bike starts?
The ball has to be in there for the starter solenoid to fully engage the starter shaft . The starter shaft pushes the pinion gear out into the ring gear . If the ball is missing the pinion gear doesn’t fully engage the ring gear and it’ll go “ clunk “ ! I bought the bike in 1994, it had 16,000 miles on it then, 40,000 now.