Wo sitzt der MAF Sensor?
Funktion des Luftmassenmessers. Der Luftmassenmesser, auch Luftmassensensor genannt, gehört zum Ansaugsystem des Motors und sitzt sowohl beim Benzin- als auch beim Dieselmotor zwischen dem Luftfilterkasten und der Drosselklappe.
Wie wird Luftmasse gemessen?
Ein Luftmassenmesser oder kurz LMM (auch mass air flow meter (MAF), Luftmassensensor bzw. LMS) ist ein in der Regelungs- und Messtechnik eingesetzter Durchflusssensor, der die Masse der pro Zeitspanne durchströmenden Luft (den Massenstrom) bestimmt.
Welche Art von Luftmassenmesser gibt es?
Der Luftmassenmesser befindet sich in der Regel direkt im Inneren des Ansaugrohres zwischen dem Luftfilter und der Drosselklappe. Es wird zwischen der älteren Bauform, dem Hitzdraht-Luftmassenmesser, und der neueren Bauform, dem Heißfilm-Luftmassenmesser, unterschieden.
Wie wird die Luftmasse im Heißfilm Luftmassenmesser gemessen?
Heißfilm-Luftmassenmesser Die durch die vorbeiströmende Ansaugluft verursachte Abkühlung des Sensors wird durch den Heizstrom wieder ausgeglichen. Über den zum Ausgleich der Temperaturdifferenz benötigten Heizstrom lässt sich die angesaugte Luftmasse ermitteln. Ein Freibrennen ist nicht mehr notwendig.
How can you tell when a MAF sensor is bad?
A bad MAF sensor can cause your vehicle to experience poor drivability issues such as engine stalling, jerking or hesitation during acceleration . This could happen while speeding up on the highway on-ramp or cruising down a city street. These issues can create dangerous situations causing accidents and injury.
What are the symptoms of a MAF sensor going bad?
These are the symptoms of a bad MAF sensor: Engine stalling, almost immediately after starting the car. Lack of power and poor acceleration. Unstable idling, especially when the A/C is on. Engine hiccup. Unable to start the car, even after turning the engine for a couple of times.
Where can I find the MAF sensor?
– Turn off the ignition of your vehicle and open its hood. – Disconnect the negative battery cable (red). Locate the mass air flow (MAF) sensor on the air intake. – Grasp the wire harness that connects the MAF sensor to the power unit in the engine compartment and gently pull it out of the MAF sensor.
Is there any way to test a MAF?
A MAF sensor can be tested without a scan tool. How? With a digital multimeter. Yes , a digital multimeter can be used in testing the Mass Air Flow (MAF) sensor. In this article I am going to briefly explain the three basic multimeter tests that are done to find out if it’s bad or not.